Lessons · Engineering · RMS of a sine wave
RMS: the DC voltage that would heat the same wire the same amount
For a sine wave, V_rms = V_peak / √2, about 0.707 of the peak. Power and heating use rms, so meters and ratings are in rms.
Hone is a place to practise a career, one idea a day. This is one of its lessons, written out in full and free to read without an account.
In beta. This lesson was written for Hone and has not yet been checked by a licensed engineer. Practice material, not professional advice. What that means.
What it is for
An oscilloscope shows 339 V on a wire the label calls 240 V. Both are right: one is the peak of the wave, the other is what a heater feels. Put the peak into a power formula and every heater in the building is sized double.
How to think about it
Peak to rms: divide by 1.414. Rms to peak: multiply by 1.414. Anything about power, heating or a rating wants rms; anything about insulation or a capacitor's voltage limit wants peak.
Worked example
V_rms = V_peak / √2 = 0.707 × V_peakThe rule for a sine wave, and only for a sine wave.
A sine wave with a 100 V peak: V_rms = 100 / 1.414 = 70.7 VPeak to rms.
The other way: 240 V rms mains has a peak of 240 × 1.414 = 339.4 VRms to peak. That is the number the insulation has to survive.
Power in a 24 Ω heater: P = V_rms² / R = 240² / 24 = 2400 WRms in the power formula, because rms is defined as the DC voltage that heats the same.
Your turn
Peak 50 V. Write the rms.
V_rms = 50 / 1.414 = V
Solve one, graded on the server
The trap
Using the peak in a power calculation. Peak squared is twice rms squared, so the power comes out double. Wiring and heaters are sized on rms; only the insulation cares about the peak.